高速电弧喷涂FeNiCrAl涂层制备工艺对涂层性能影响

FeNiCrAl涂层是一种用作轴类零部件的表面耐磨防护材料,为深入研究高速电弧喷涂工艺对FeNiCrAl涂层性能的影响机理,对不同喷涂参数下制备的涂层的组织结构、结合强度、物相组成和显微硬度等性能进行分析表征,探究“喷涂电流-涂层组织结构-结合强度”之间的关系。结果表明：喷涂电流对涂层的组织致密性及结合强度影响较大;喷涂电流200 A、电压34 V、喷涂距离160 mm的工艺参数下制备的FeNiCrAl涂层组织致密,孔隙率约8.76%,结合强度52.3 MPa,涂层硬度约626 HV0.1,约为基体硬度的1.6倍;影响机理与Fe-Al金属间化合物和Cr0.19 Fe0.1 Ni0.11固溶体在涂层内部均匀弥散分布有关。     

多喷嘴构型的轴对称氢氧加热器设计与仿真

为了使氢氧燃烧加热器满足自由射流试验台工作需要并获得均匀的出口气流参数,采用同轴剪切式7个喷嘴轴对称构型喷注器,利用CFD仿真软件对其进行了三维反应流场计算,燃烧模型采用氢氧单步反应模型,获得了设计工况下的参数.计算结果表明:燃烧效率随着中心喷嘴与外围喷嘴距离L与喷注面板半径R之比(L/R)的增大先上升后下降;喷注面板的温度随着L/R的增大而降低,最终维持在600K左右;加热器出口的氧气摩尔分数以及总温的均匀性基本不随着L/R变化而变化;出口主流区的马赫数在6左右满足设计要求.在各个喷嘴的影响区域大致相等时,加热器综合性能良好.氢氧速度比越大,完全燃烧所需区域越短,喷注面板温度越高.与单喷嘴、19个喷嘴的加热器比较发现7个喷嘴的构型较为合理.      

基于激光多普勒原理的极低风速测量实验

介绍了利用激光多普勒效应进行风速测量的原理及定点遥测原理,分析了探测气溶胶颗粒大小的要求,并以此搭建了一套极低风速测量系统。同时分析了系统的测速精度,以及安装角度对测量结果的影响。最后分别开展了转台实验、直线导轨实验和风洞实验,实验结果表明,该极低风速测量系统的测量误差基本可以控制在001 m/s以内,当风洞工作介质为未经处理的环境空气时,系统可以获得稳定可靠的信号,测量结果与高性能仪器十分接近。     

基于PIV技术的单圆孔脉冲射流流场特征

对稳态射流及脉冲射流冲击靶板时的流场特性结构进行了探索和分析。采用高频粒子图像测速技术,在射流管口到冲击靶板间距为6倍管径的条件下,对稳态射流进口雷诺数为6 000的稳态射流及脉冲频率为20 Hz的脉冲射流进行了实验测量,得到了射流核心区、壁面射流区及滞止区内的速度分布。研究发现:①由于射流剪切作用的影响,脉冲射流核心区的最大轴向脉动速度为稳态射流的3倍。②滞止区内,由于射流的剪切作用和壁面的滞止作用,导致了脉冲射流轴向速度梯度最大为稳态射流的2倍,同时,滞止区内的最大脉动速度是稳态射流脉动速度的3倍。③脉冲射流对壁面的卷吸以及旋涡的产生和传播过程,破坏了壁面射流区稳定的速度边界层。相比稳态射流,脉冲射流的流场增加了湍流相干结构的含能并产生周期性的大尺度卷吸涡。     

Advances in critical technologies for hypersonic and high-enthalpy wind tunnel

Hypersonic and high-enthalpy wind tunnels and their measurement techniques are the cornerstone of the hypersonic flight era that is a dream for human beings to fly faster, higher and further. The great progress has been achieved during the recent years and their critical technologies are still in an urgent need for further development. There are at least four kinds of hypersonic and high-enthalpy wind tunnels that are widely applied over the world and can be classified according to their operation modes. These wind tunnels are named as air-directly-heated hypersonic wind tunnel, light-gas-heated shock tunnel, free-piston-driven shock tunnel and detonation-driven shock tunnel, respectively. The critical technologies for developing the wind tunnels are introduced in this paper, and their merits and weakness are discussed based on wind tunnel performance evaluation. Measurement techniques especially developed for high-enthalpy flows are a part of the hypersonic wind tunnel technology because the flow is a chemically reacting gas motion and its diagnosis needs specially designed instruments. Three kinds of the measurement techniques considered to be of primary importance are introduced here, including the heat flux sensor, the aerodynamic balance, and optical diagnosis techniques. The techniques are developed usually for conventional wind tunnels, but further improved for hypersonic and high-enthalpy tunnels. The hypersonic ground test facilities have provided us with most of valuable experimental data on high-enthalpy flows and will play a more important role in hypersonic research area in the future. Therefore, several prospects for developing hypersonic and high-enthalpy wind tunnels are presented from our point of view.     

Sensitivity analysis of flowfield modeling parameters upon the flow structure and aerodynamics of an opposing jet over a hypersonic blunt body

Implementation of an opposing jet in design of a hypersonic blunt body significantly modifies the external flowfield and yields a considerable reduction in the aerodynamic drag. This study aims to investigate the effects of flowfield modeling parameters of injection and freestream on the flow structure and aerodynamics of a blunt body with an opposing jet in hypersonic flow. Reynolds-Averaged Navier-Stokes (RANS) equations with a Shear Stress Transport (SST) turbulence model are employed to simulate the intricate jet flow interaction. Through utilizing a Non-Intrusive Polynomial Chaos (NIPC) method to construct surrogates, a functional relation is established between input modeling parameters and output flowfield and aerodynamic quantities in concern. Sobol indices in sensitivity analysis are introduced to represent the relative contribution of each parameter. It is found that variations in modeling parameters produce large variations in the flow structure and aerodynamics. The jet-to-freestream total-pressure ratio, jet Mach number, and freestream Mach number are the major contributors to variation in surface pressure, demonstrating an evident location-dependent behavior. The penetration length of injection, reattachment angle of the shear layer, and aerodynamic drag are also most sensitive to the three crucial parameters above. In comparison, the contributions of freestream temperature, freestream density, and jet total temperature are nearly negligible.     

空中发射初始状态对运载火箭有效载荷的影响

空中发射可以明显提高火箭有效载荷,减少火箭发射场地的数量和高额的维护经费,缩短发射周期。本文研究了空中发射初始状态对运载火箭有效载荷的影响,通过飞行轨道的模型简化,首先建立了火箭飞行的数学模型,然后定量地分析了发射高度和发射速度对火箭入轨后有效载荷的影响。研究结果表明：若提高发射高度和发射速度,可以明显增加有效载荷,且基本发射高度、发射速度分别与有效载荷表现为线性关系。相对地面发射来说,如果初始高度达到30千米,有效载荷提升到1.63倍;如果初始高度达到30千米,初始速度达到1000米每秒（约3马赫）,有效载荷将是传统地面发射的5.43倍。单纯从初始高度和速度的因素看,初始发射速度对有效载荷提升的影响更显著,故在考虑经济性情况下设计发射平台时应更加注重发射速度的提高。     

先进的热防护方法及在飞行器的应用前景初探

随着航天技术的发展,飞行器的热环境面临着新的变化,对热防护提出了挑战。对各类主动热防护方式的原理、研究进展和应用现状进行了归纳总结。结合飞行器未来发展,提出了适应于未来应用的基于相变工质的对流冷却、自适应膜相变冷却和发汗冷却的系统性主动热防护方式。并以此为基础,提出了结合被动、半被动和主动热防护的飞行器全时域综合热管理思路。     

Mechanism parameters optimization of bionic frog jumping robot based on velocity directional manipulability measure

以速度方向可操作度作为跳跃性能的评价指标,从机构设计角度寻求改善仿蛙跳跃机器人跳跃性能的方法.在仿蛙跳跃机器人机构模型的基础上,建立了起跳阶段的运动学方程,得到机器人从关节空间到质心运动空间的速度映射关系,结合速度方向可操作度,利用优化算法对仿蛙跳跃机器人的机构参数进行优化,使机器人的跳跃性能达到最佳.优化结果表明,运用速度方向可操作度理论,对跳跃机器人机构参数进行优化研究是有效可行的.     

The effects of the solar magnetic polarity and the solar wind velocity on Bz-component of the interplanetary magnetic field

We have studied the effect of both solar magnetic polarity and the solar wind velocity on the Bz-component of the interplanetary magnetic field, IMFBz, for the minimum activity of the solar cycles 21, 22, 23 and 24. We made a statistical study of IMFBz in the first section which is considered as an extension of Lyatsky et al. (2003). They made a statistical study of IMFBz for two periods of minimum solar activity 22 and 23 related to 1985–1987 and 1995–1997 when the solar magnetic field had opposite polarity. Our results seem to be consistent with the results obtained by Lyatsky et al. (2003). We found that there is a dependence of IMFBz on the IMFBx and the solar magnetic polarity for the minimum periods of the selected four solar cycles. In addition, we found that there is a dependence of IMFBz on the solar wind velocity.